Calibration devices

These are small, airtight containers which fit exactly onto the respective sensor and form an airtight enclosure around the sensor. The lower screw-on part is then filled with the humidity standard material. The desired humidity level is reached following a settling period of typically 60 minutes at a constant temperature. The equipment can now be adjusted to match the reference humidity value. We offer suitable devices for every ROTRONIC sensor and can also construct an appropriate calibration device for your humidity measurement equipment.

HL-20-CAL

Calibration & adjustment device for HL-20
Learn More
ER-12K

Push-on calibration devices, Ø 12 mm

Gasket with O-ring and thumb screw. For 1 probe, Brass, nickel-plated.

Learn More
ERV-15

Push-on calibration devices, Ø 15..15 mm

Push-on calibration devices. Gasket with O-ring and thumb screw. For 1 probe, Vertical calibration pos., Brass, nickel-plated

Learn More
EGS

Calibration devices for all sword probes.
Learn More
EMV-25

Screw-on calibration devices, Ø 25 mm (PG11)

Gasket with seal face on probe. Cannot be used for HC2-S probes. For 1 probe, Vertical calibration pos., Aluminium, anodised.

Learn More
EDM-15/15

Push-on calibration devices for 2 probes, Ø 14…15 mm

Gasket with O-ring and thumb screw. For 2 probes, Brass, nickel-plated.

Learn More
ER-05

Push-on calibration devices, Ø 4…5 mm

Gasket with O-ring and thumb screw. For 1 probe, Brass, nickel-plated.

Learn More
ER-15

Push-on calibration device Ø 14…15 mm

Gasket with O-ring and thumb screw. For 1 probe, Brass, nickel-plated.

Learn More